KTR CR, spol. s r.o. | Brněnská 559 | 569 43 Jevíčko | T +420 461 325 014 |

KTR-SI se spojkou ROTEX®

KTR-SI se spojkou ROTEX<sup>®</sup>
  • idle rotating torque limiter
  • ratched torque limiter design
  • hardened surfaces
  • bezúdržbové
  • accuracy 15%
  • 120°C maximální provozní teplota
  • axilání montáž
  • nutno přihlédnout ke vzdálenosti hřídelí

Product features

  • Omezovač kroutícího momentu – bezvůlová pojistná spojka

  • Ochrana proti přetížení až do 8.200 Nm

  • K dispozici také v synchronním provedení

  • Kombinace s torzně pružnou spojkou ROTEX®

  • Propojení hřídel – hřídel

  • Snadná montáž

  • Robustní provedení

  • Konstrukce pro vysoké otáčky – rozpojení spojky

Contact

Prodej
T +420 461 619 587
E ktr-cz@ktr.com
Technická podpora
T +420 461 325 014
E ktr-cz@ktr.com

For exact dimensioning torque limiters latest simulation and calculation programmes are available. Therefore let us know many data of your drive. The more precise these data are, the more precise are the results of calculation. Make use of this possibility and discuss with us the application in advance.

KTR-SI se spojkou ROTEX®
Show specifications

Information about selection of torque limiters

To make sure that the torque limiter does not yet release with torque peaks related to the process, the switching torque of the coupling should exceed the maximum operating torque by at least 30 % (see diagramme).

Torque limiters and overload systems which re-engage automatically should only be used with a reduced speed for higher release torques. Frequent or longer slipping or ratching increases the wear of the torque limiter.

After the torque limiter has disconnected driving and driven side in case of overload, it may take some time before the drive comes to standstill because of a high inertia in the drive train. This may cause higher wear on the torque limiter and the overload system re-engaging automatically. That is why we recommend the use of the overload system KTR-SI as an idle rotation type for drives with big inertias or with higher speeds.

We basically recommend electronic monitoring of the torque limiters in order to protect the drive in case of overload.

We will be pleased to support you with technical questions and with the selection of torque limiters. For that purpose we dispose of the latest simulation and calculation programs. Here the following fact applies: The more detailed the data, the more accurate are the calculation results.

292
Share
 
 
 
 
 
 
 
 
 
 
 
 
KTR360°